ABB PFEA112-20 3BSE030369R0020 Tension Control Electronics Module

Description

Hardware & Electrical Specifications

• Model：PFEA112‑20
• Part Number：3BSE030369R0020
• Module Type：Tension Control Electronics Module
• Mounting：DIN‑rail mounting, IP20 protection grade
• Power supply：24 V DC (18‑36 V DC), power consumption 7.5 WABB Group
• Sensor channel：2‑channel load‑cell input; 330 Hz sensor excitation 0.5 A rmsABB Group
• Analog I/O：configurable analog input, 0‑10 V / 4‑20 mA analog output
• Communication：Profibus‑DP fieldbus interface
• Display：2×16‑character multi‑language LCD with setting keys
• Measuring accuracy：±0.1% full scale
• Control function：integrated PID auto‑tune closed‑loop tension control
• Galvanic isolation：between sensor side and control logic side
• On‑board protection：overload protection, sensor break detection, signal filtering, short‑circuit protection
• Compatibility note：Cannot run standalone; match ABB PFCL / PFTL tension sensors, must match host system configuration.

Environmental Specifications

• Operating temperature：‑10 ℃ ~ +55 ℃
• Storage temperature：‑40 ℃ ~ +70 ℃
• Relative humidity：5%‑95% non‑condensing
• Installation location：Inside industrial control cabinet
• EMC compliance：IEC 61000‑6‑2
• Certifications：CE, UL61010C

Mechanical Data

• Weight：approx 0.45 kg
• Dimension：145 mm × 100 mm × 45 mm
• Terminals：screw terminal blocks for sensor, power, analog signal and Profibus‑DP bus
• Recommended wire cross‑section：0.75 mm²‑2.5 mm² copper cable for signal terminals
• Terminal tightening torque：0.6‑1.0 N·m

Main Functions

1. Supply excitation and acquire measuring signal from dual tension load‑cells.
2. Calculate tension value of individual channel, sum(A+B) and difference(A‑B).
3. Built‑in PID closed‑loop tension control with auto‑tune function, output control signal to drive / brake.
4. Configurable digital filtering for suppressing mechanical vibration and site electromagnetic noise.
5. Analog input‑output for local signal interconnection with PLC and drive system.
6. Local LCD display for tension reading, PID parameter setting and unit status diagnosis.
7. Profibus‑DP communication for remote reading tension value, alarm status and parameter download.
8. Channel‑level self‑diagnosis: detect sensor break, overload, cable fault, report alarm status.
9. LED status indication:
   • Green LED：Power supply normal, unit healthy
   • Yellow LED：Measuring signal / Profibus‑DP communication active
   • Red LED：Over‑load / sensor fault / control‑loop fault / unit hardware fault

Installation & Wiring Requirements

1. Cut off power supply before wiring or replacement. Mount PFEA112‑20 firmly on DIN‑rail inside cabinet. Hot‑swap is forbidden.
2. Connect load‑cell sensor cable, power cable, analog signal and Profibus‑DP bus cable strictly per wiring drawing; separate weak‑signal sensor cables from high‑power cables to reduce electromagnetic interference.
3. Complete protective grounding according to ABB Pressductor tension‑system specification.
4. After replacement, perform load‑cell calibration, set PID parameters, complete Profibus‑DP station address configuration; verify measuring, closed‑loop control and bus communication function before commissioning.
5. Replacement note: sensor calibration and PID parameter download are mandatory after unit replacement. Cannot directly swap with PFEA111 series, PFEA112 has integrated closed‑loop control function.