ABB XVC770AE 3BHE006414R0001 High‑Voltage Detection HVD Board

Description

Hardware & Electrical Specifications

• Model：XVC770AE
• Part Number：3BHE006414R0001
• Module Type：High‑Voltage Detection HVD Board
• Bus Interface：Internal converter system back‑plane signal bus
• Signal Channel：DC‑link high‑voltage sampling input, analog measuring output, hardware fault trigger output
• Power supply：24 V DC (18‑32 V DC)
• Max power consumption：10 W
• Galvanic isolation：≥3000 V AC between high‑voltage sampling side and control‑logic side
• Dielectric strength：3000 V AC 1 minute
• Insulation resistance：＞100 MΩ @ 500 V DC
• On‑board protection：ESD protection, high‑voltage surge suppression, hardware voltage‑comparator latch circuit, conformal coated PCB
• Compatibility note：Cannot run standalone; dedicated for ACS6000 / Megadrive‑LCI converter rack, must match corresponding system firmware version.

Environmental Specifications

• Operating temperature：‑10 ℃ ~ +60 ℃
• Storage temperature：‑40 ℃ ~ +85 ℃
• Relative humidity：5%‑95% non‑condensing
• Installation location：Inside high‑power converter cabinet rack
• EMC compliance：IEC 61000‑6‑2
• Certifications：CE

Mechanical Data

• Installation：Plug‑in rack‑mount eurocard board
• Interfaces：Internal back‑plane connector; high‑voltage sampling terminals; fault‑signal output terminals
• Recommended wire cross‑section：0.75 mm²‑2.5 mm² copper cable for signal terminals
• Terminal tightening torque：0.6‑1.0 N·m
• Weight：approx 0.78 kg
• Dimension：Standard Euro‑card for ABB high‑power converter rack

Main Functions

1. Real‑time sampling and isolation conversion of converter DC‑link high‑voltage signal.
2. Hardware‑level fast over‑voltage / under‑voltage detection, independent of main‑processor software logic.
3. Output fault trigger signal to control system to trigger trip action when voltage threshold is exceeded.
4. Send scaled analog measuring data to main processor for closed‑loop control and voltage monitoring.
5. Board‑level self‑diagnosis: detect sampling circuit abnormality and board power‑supply failure, report fault codes to converter system.
6. LED status indication:
   • Green LED：Power supply normal, board logic healthy
   • Yellow LED：High‑voltage sampling signal active
   • Red LED：Over‑voltage / under‑voltage fault / sampling channel fault / board hardware fault

Installation & Wiring Requirements

1. Cut off cabinet total power before replacement. Insert XVC770AE into assigned rack slot and tighten mounting screws. Hot‑swap is strictly forbidden.
2. Connect DC‑link sampling cables and fault‑signal cables strictly per wiring drawing; strictly separate high‑voltage sampling cables and low‑voltage signal cables to reduce electromagnetic interference.
3. Cabinet protective grounding shall comply with ABB ACS6000 / Megadrive‑LCI grounding specification.
4. After replacement, confirm firmware compatibility, complete high‑voltage sampling calibration and over‑voltage protection simulation test before commissioning.
5. Replacement note：Cross‑version substitution requires hardware‑firmware compatibility validation.