GE IC610MDL116A Series‑One 4‑Channel Analog Input Module

Description

Hardware & Electrical Specifications

‑ Model：IC610MDL116A ‑ Part Number：IC610MDL116A ‑ Module Type：Series‑One 4‑Channel Differential Analog Input Module ‑ Mounting：Plug‑in into Series‑One I/O rack backplane slot ‑ Backplane power：5 VDC from rack backplane, typical consumption 180 mA ‑ Input channels：4 differential analog input channels ‑ Input signal types：jumper configurable 1‑5 VDC or 4‑20 mA field signals ‑ Input impedance：9.5 kΩ for voltage mode ‑ A‑D conversion：successive‑approximation ADC, 8‑bit resolution, max conversion time 2 ms per channel ‑ Accuracy：±1 % full‑scale at 25 ℃, max linearity error ±0.8 % FS ‑ Communication interfaces：Series‑One proprietary backplane bus to CPU ‑ Mechanical feature：module mechanical keying for anti‑mis‑insertion ‑ PCB treatment：Conformal coated for dust‑moisture‑corrosion resistance ‑ On‑board protection：transient surge suppression, differential common‑mode noise rejection, hardware self‑diagnosis ‑ Compatibility note：Cannot run standalone; must match Series‑One CPU and I/O rack; full analog‑loop simulation test mandatory after replacement.

Environmental Specifications

‑ Operating temperature：0 ℃ ~ +60 ℃ ‑ Storage temperature：‑40 ℃ ~ +85 ℃ ‑ Relative humidity：5%‑95% non‑condensing ‑ Installation location：Indoor industrial control cabinet ‑ EMC compliance：IEC 61000‑6‑2 ‑ Certifications：CE, UL hazardous‑location certification

Mechanical Data

‑ Weight：approx 0.30 kg ‑ Dimension：Standard Series‑One single‑slot plug‑in module form‑factor ‑ Handling note：ESD‑sensitive analog acquisition circuit, anti‑static wrist‑strap mandatory during handling ‑ Terminal tightening torque：0.6‑1.0 N·m

Main Functions

1. Acquire differential‑mode analog signals from field 4‑20 mA / 1‑5 VDC transmitters and process sensors.
2. Perform signal conditioning and A‑D conversion, transfer digital process values to Series‑One PLC CPU over backplane bus.
3. Differential‑input architecture suppresses ground‑loop interference and industrial field common‑mode noise.
4. LED status indication:   ‑ Green LED：Module power and self‑test OK status

Installation & Wiring Requirements

1. Cut off rack backplane power before replacement. Hot‑swap is forbidden. Strict anti‑static protection when handling module.
2. Insert module fully into Series‑One rack slot and lock; set on‑board jumpers for each channel’s voltage/current mode according to field‑transmitter type.
3. Analog‑signal wiring strictly follow GE Series‑One hardware manual; use shielded twisted‑pair cable, separate analog wiring from high‑power cables, connect shielding to dedicated protective ground terminal.
4. Complete protective grounding according to GE system specification.
5. After replacement: power‑on, verify OK LED status, perform channel calibration and signal‑loop fault simulation test.
6. Replacement note: Verify CPU firmware compatibility; full analog‑loop simulation test mandatory before unit put‑into‑service.