GE IS220PAICH1B PAI Analog Input Module

Description

Hardware & Electrical Specifications

‑ Model：IS220PAICH1B ‑ Part Number：IS220PAICH1B ‑ Module Type：PAI Analog Input Module ‑ Mounting：Installed in Mark VIe I/O pack rack ‑ Power supply：24 VDC field power supplied via I/O pack backplane ‑ Input channels：Multi‑channel analog input, supports 4‑20 mA current signal and ±10 V voltage signal ‑ Communication interfaces：   • IONet interface for communication with VCMI / controller   • Backplane interface inside I/O pack ‑ PCB treatment：Conformal coated for dust‑moisture‑corrosion resistance ‑ On‑board protection：ESD protection, MOV surge suppression, channel signal isolation, module self‑diagnosis circuit ‑ Compatibility note：Cannot run standalone; must match Mark VIe I/O pack rack and corresponding controller hardware; full signal‑loop simulation test mandatory after replacement.

Environmental Specifications

‑ Operating temperature：‑40 ℃ ~ +70 ℃ ‑ Storage temperature：‑40 ℃ ~ +85 ℃ ‑ Relative humidity：5%‑95% non‑condensing ‑ Installation location：Indoor turbine control cabinet ‑ EMC compliance：IEC 61000‑6‑2 ‑ Certifications：CE

Mechanical Data

‑ Weight：approx 0.35 kg ‑ Dimension：Standard Mark VIe I/O pack module form‑factor ‑ Handling note：ESD‑sensitive PCB; analog signal acquisition circuit, anti‑static wrist‑strap mandatory during handling ‑ Terminal tightening torque：0.6‑1.0 N·m

Main Functions

1. Acquire field analog signals including 4‑20 mA and ±10 V from transmitters and process instruments.
2. Perform analog‑to‑digital conversion, signal filtering and scaling for process variables.
3. Transmit converted digital process data to main controller through IONet field bus.
4. Execute continuous self‑diagnosis for each input channel, detect open‑circuit, over‑range and module hardware faults, and report fault status.
5. LED status indication:   ‑ Green LED：Module power supply normal / RUN status   ‑ Yellow LED：Channel signal activity indicator   ‑ Red LED：Module FAIL / channel fault alarm

Installation & Wiring Requirements

1. Cut off I/O pack rack power supply before replacement. Hot‑swap is forbidden. Strict anti‑static protection when handling PCB board.
2. Insert module into designated slot of I/O pack rack, lock module latch to ensure reliable backplane contact.
3. Field analog signal wiring strictly follow GE Speedtronic Mark VIe wiring manual; signal cables shall be separated from high‑power cables; connect shielding to dedicated ground terminal.
4. Complete protective grounding according to GE system specification.
5. After replacement: verify I/O pack power‑on status, check each channel signal reading, perform analog‑loop commissioning test.
6. Replacement note: For TMR triple‑redundant system application, hardware consistency and firmware‑version matching shall be verified; full signal‑loop simulation test mandatory before unit put‑into‑service.